Bulbs
Flower Basics
Flower Beds & Specialty Gardens
Flower Garden
Garden Furniture
Garden Gnomes
Garden Seeds
Garden Sheds
Garden Statues
Garden Tools & Supplies
Gardening Basics
Green & Organic
Groundcovers & Vines
Growing Annuals
Growing Basil
Growing Beans
Growing Berries
Growing Blueberries
Growing Cactus
Growing Corn
Growing Cotton
Growing Edibles
Growing Flowers
Growing Garlic
Growing Grapes
Growing Grass
Growing Herbs
Growing Jasmine
Growing Mint
Growing Mushrooms
Orchids
Growing Peanuts
Growing Perennials
Growing Plants
Growing Rosemary
Growing Roses
Growing Strawberries
Growing Sunflowers
Growing Thyme
Growing Tomatoes
Growing Tulips
Growing Vegetables
Herb Basics
Herb Garden
Indoor Growing
Landscaping Basics
Landscaping Patios
Landscaping Plants
Landscaping Shrubs
Landscaping Trees
Landscaping Walks & Pathways
Lawn Basics
Lawn Maintenance
Lawn Mowers
Lawn Ornaments
Lawn Planting
Lawn Tools
Outdoor Growing
Overall Landscape Planning
Pests, Weeds & Problems
Plant Basics
Rock Garden
Rose Garden
Shrubs
Soil
Specialty Gardens
Trees
Vegetable Garden
Yard Maintenance
How to Replace a Belt on a Scotts S1742 Lawn Mower
How to Replace a Belt on a Scotts S1742 Lawn Mower. Scotts S1642, S1742 and S2046 are all submodels built under the Scotts brand name by John Deere. Essentially, these models are John Deere tractors and mowers without the trademark John Deere logo or green and yellow paint scheme. Just as standard John Deere lawn mowers utilize a suspended deck and...
Scotts S1642, S1742 and S2046 are all submodels built under the Scotts brand name by John Deere. Essentially, these models are John Deere tractors and mowers without the trademark John Deere logo or green and yellow paint scheme. Just as standard John Deere lawn mowers utilize a suspended deck and drive belt system, Scotts mowers have the same equipment. When the drive belt stretches beyond the point where the mower deck can compensate, you must replace the belt with a new one or risk having the belt break, which would leave the mower deck disabled.
Things You'll Need
2-by-4s
Drive your Scotts S1742 mower onto level, stable ground and set the parking brake.
Disengage the PTO, or blade, lever to stop the blades from rotating. Disengaging the PTO lever also creates additional slack in the drive belt.
Raise the adjustment lever for the mower deck to position the deck as high off the ground as possible. Slide two-by-fours under the front and back of the deck or under the left and right side of the deck. Lower the deck onto the blocks to take tension off the suspension rods.
Remove the cotter pins from the suspension rods. Pull the washers and the suspension rods off the rod pins. Lower the suspension rods into a horizontal position.
Locate the drive pulley mounted under the Scotts mower and pull the drive belt off the pulley.
Remove the deck from the two-by-fours and slide the deck out.
Remove the belt from the Scotts mower deck. If needed, make a note of how the belts route before you take the belt off. Place the new belt on the deck.
Slide the deck under the Scotts tractor, then place the deck back on the two-by-fours.
Place the belt over the pulley mounted under the engine.
Line the suspension rods up with the rod pins. Slide the washers over the pins, then secure them with the cotter pins.
Remove the two-by-fours from under the deck. Lower the deck to its normal cutting height.
