Bulbs
Flower Basics
Flower Beds & Specialty Gardens
Flower Garden
Garden Furniture
Garden Gnomes
Garden Seeds
Garden Sheds
Garden Statues
Garden Tools & Supplies
Gardening Basics
Green & Organic
Groundcovers & Vines
Growing Annuals
Growing Basil
Growing Beans
Growing Berries
Growing Blueberries
Growing Cactus
Growing Corn
Growing Cotton
Growing Edibles
Growing Flowers
Growing Garlic
Growing Grapes
Growing Grass
Growing Herbs
Growing Jasmine
Growing Mint
Growing Mushrooms
Orchids
Growing Peanuts
Growing Perennials
Growing Plants
Growing Rosemary
Growing Roses
Growing Strawberries
Growing Sunflowers
Growing Thyme
Growing Tomatoes
Growing Tulips
Growing Vegetables
Herb Basics
Herb Garden
Indoor Growing
Landscaping Basics
Landscaping Patios
Landscaping Plants
Landscaping Shrubs
Landscaping Trees
Landscaping Walks & Pathways
Lawn Basics
Lawn Maintenance
Lawn Mowers
Lawn Ornaments
Lawn Planting
Lawn Tools
Outdoor Growing
Overall Landscape Planning
Pests, Weeds & Problems
Plant Basics
Rock Garden
Rose Garden
Shrubs
Soil
Specialty Gardens
Trees
Vegetable Garden
Yard Maintenance
How to Adjust the Carburetor on a Husqvarna 445 Chain Saw
How to Adjust the Carburetor on a Husqvarna 445 Chain Saw. The carburetor on a Husqvarna 445 chain saw regulates engine speed. Air and fuel are mixed in the carburetor, and this mix can be adjusted. The carburetor is controlled using the throttle. When the chain saw's carburetor is adjusted properly, the chain saw will accelerate quickly and...
The carburetor on a Husqvarna 445 chain saw regulates engine speed. Air and fuel are mixed in the carburetor, and this mix can be adjusted. The carburetor is controlled using the throttle. When the chain saw's carburetor is adjusted properly, the chain saw will accelerate quickly and cleanly without any stuttering. A properly adjusted carburetor also stops the chain from rotating on idle. You can adjust the carburetor in a Husqvarna 445 chain saw quickly and easily.
Start the Husqvarna 445 chain saw. Watch the chain as it idles and make sure it's not rotating. If the chain is rotating, adjust the carburetor idle speed with the carburetor screws. The screws are located on the carburetor, which is between the fuel tank and the starter handle on the left side viewed from behind.
Turn the T-screw clockwise with the engine running until the chain starts to rotate. Then turn the T-screw counterclockwise until the chain stops.
Listen to the engine after you've made the adjustment. The engine should run smoothly in all positions. Make further adjustments to the T-screw if it doesn't.
Turn the Husqvarna 445 chain saw off, then turn it back on to test how it starts and accelerates. A too-lean mix on the L-jet screw can cause starting problems and poor acceleration. If the H-jet screw is too lean, there will be less overall power available.
Tips & Warnings
Take the Husqvarna 445 chain saw in for service if you are unable to get the chain to stop at idle.
