Bulbs
Flower Basics
Flower Beds & Specialty Gardens
Flower Garden
Garden Furniture
Garden Gnomes
Garden Seeds
Garden Sheds
Garden Statues
Garden Tools & Supplies
Gardening Basics
Green & Organic
Groundcovers & Vines
Growing Annuals
Growing Basil
Growing Beans
Growing Berries
Growing Blueberries
Growing Cactus
Growing Corn
Growing Cotton
Growing Edibles
Growing Flowers
Growing Garlic
Growing Grapes
Growing Grass
Growing Herbs
Growing Jasmine
Growing Mint
Growing Mushrooms
Orchids
Growing Peanuts
Growing Perennials
Growing Plants
Growing Rosemary
Growing Roses
Growing Strawberries
Growing Sunflowers
Growing Thyme
Growing Tomatoes
Growing Tulips
Growing Vegetables
Herb Basics
Herb Garden
Indoor Growing
Landscaping Basics
Landscaping Patios
Landscaping Plants
Landscaping Shrubs
Landscaping Trees
Landscaping Walks & Pathways
Lawn Basics
Lawn Maintenance
Lawn Mowers
Lawn Ornaments
Lawn Planting
Lawn Tools
Outdoor Growing
Overall Landscape Planning
Pests, Weeds & Problems
Plant Basics
Rock Garden
Rose Garden
Shrubs
Soil
Specialty Gardens
Trees
Vegetable Garden
Yard Maintenance
How do I Remove the Rear Wheel of a Riding Lawn Mower That Is Not Held by 4 Bolts?
How do I Remove the Rear Wheel of a Riding Lawn Mower That Is Not Held by 4 Bolts?. Whether you need to replace a riding mower's tire or do some other routine maintenance around the transmission area, the eventual removal of a riding mower's rear wheel is inevitable. The two methods commonly used to attach rear wheels to lawnmowers are bolted hubs...
Whether you need to replace a riding mower's tire or do some other routine maintenance around the transmission area, the eventual removal of a riding mower's rear wheel is inevitable. The two methods commonly used to attach rear wheels to lawnmowers are bolted hubs or a snap ring retainer. The latter consists of the rear wheel fitted directly onto the drive axles and held in place with a snap ring. If bolts are not visible on the exterior of the wheel, a snap ring and flat washer holds the wheel in place.
Things You'll Need
Bricks or wooden blocks
Small flat-head screwdriver
Large flat-head screwdriver
Light oil
Park the mower on a sidewalk or driveway. This provides a hard surface for jacking and blocking the rear of the mower to assist in removing the wheel.
Set the parking brake on the mower and place the transmission in reverse. Set a brick or square 4 x 4 block against the front wheels to prevent the mower from rolling while jacking the mower up.
Jack up the rear of the mower with a car jack. With the rear tire slightly off the ground, place a stack of bricks or boards under the rear transmission to hold the mower in position.
Remove the plastic dust cover from the center of the rear wheel. Use a small flat-head screwdriver to pry the dust cover off to expose the snap ring and washer.
Remove the snap ring attached to the axle. Position a large regular screwdriver into one of the two gaps between the inside diameter of the snap ring and the circumference of the axle. Twist the screwdriver in either direction to lift the snap ring out of its groove. Set the snap ring in the dust cover for safekeeping.
Remove the flat washer from around the axle by hand and set it into the dust cover.
Grasp the wheel with both hands and pull it off the axle. Wiggle the wheel slightly back and forth to work the wheel from the axle. A square key between the wheel and axle holds the wheel in place--keep track of it for re-installing the wheel later.
Tips & Warnings
Spray light oil around the wheel and axle to help loosen stubborn wheels.
