Bulbs
Flower Basics
Flower Beds & Specialty Gardens
Flower Garden
Garden Furniture
Garden Gnomes
Garden Seeds
Garden Sheds
Garden Statues
Garden Tools & Supplies
Gardening Basics
Green & Organic
Groundcovers & Vines
Growing Annuals
Growing Basil
Growing Beans
Growing Berries
Growing Blueberries
Growing Cactus
Growing Corn
Growing Cotton
Growing Edibles
Growing Flowers
Growing Garlic
Growing Grapes
Growing Grass
Growing Herbs
Growing Jasmine
Growing Mint
Growing Mushrooms
Orchids
Growing Peanuts
Growing Perennials
Growing Plants
Growing Rosemary
Growing Roses
Growing Strawberries
Growing Sunflowers
Growing Thyme
Growing Tomatoes
Growing Tulips
Growing Vegetables
Herb Basics
Herb Garden
Indoor Growing
Landscaping Basics
Landscaping Patios
Landscaping Plants
Landscaping Shrubs
Landscaping Trees
Landscaping Walks & Pathways
Lawn Basics
Lawn Maintenance
Lawn Mowers
Lawn Ornaments
Lawn Planting
Lawn Tools
Outdoor Growing
Overall Landscape Planning
Pests, Weeds & Problems
Plant Basics
Rock Garden
Rose Garden
Shrubs
Soil
Specialty Gardens
Trees
Vegetable Garden
Yard Maintenance
How to Get Sap Out of Cedar Trees
How to Get Sap Out of Cedar Trees. All trees produce a sticky sap underneath their bark. Maple trees are famous for their sap which is collected and converted into syrup, but it's possible to collect sap from any tree. If you have an abundance of cedar trees in your backyard, you may want to collect the sap to use or to teach children about the sap...
All trees produce a sticky sap underneath their bark. Maple trees are famous for their sap which is collected and converted into syrup, but it's possible to collect sap from any tree. If you have an abundance of cedar trees in your backyard, you may want to collect the sap to use or to teach children about the sap collection process, known as tapping.
Things You'll Need
5/8-inch spade drill bit
1/2-inch PVC pipe
Mallet
Wire
Bucket
Cloth
Jar
Drill a 1-1/2- to 2-inch-deep hole into the trunk of the cedar tree using a 5/8-inch spade drill bit as recommended by the Minnesota Department of Natural Resources. Aim the drill upward to create a slight slant when drilling.
Cut a piece of 1/2-inch PVC pipe to a length of 4 inches to create your spile. The spile goes into the tree to funnel out the sap. You can purchase a metal spile instead of making one.
Position spile on the edge of the drilled hole and gently tap it with a small mallet. Continue tapping until the spile is wedged into the tree with the front sticking out. Do not tap the spile all the way into the tree.
Wrap a piece of wire around your spile and around the handle of a bucket so the bucket hangs below the spile. Store-bought spiles allow you to hang the bucket directly on the spile and a small protrusion on top holds the handle in place. Cover the bucket and spile with a piece of cloth to prevent falling leaves from landing in the bucket.
Check the bucket at the end of the day for any sap. Pour the sap into a jar and replace the bucket to collect more sap.
Tips & Warnings
When collecting sap repeatedly from the same tree, drill the new hole several inches above the previous hole to avoid damaging the tree too much in one area.
